Outside Tire Paint Agent Aucde MN2400

|Function|

High-adhesion water-based green tire outside paint

|Technical Data|

Composition: aqueous suspension of fillers and bonding agents

Appearance: black liquid

PH: approx 10.0

|Description|

Aucde MN2400 is sprayed onto the outer surface of the green tire. The product has an low tendency to mold fouling resulting in high curing cycle numbers without mold cleaning. lt allows a strong adhesion in the splice regions. Therefore, it does not affect the rubber-to-rubber adhesion in the splice regions. The product is very efficient in air bleeding and mold flow properties, which effectively reduces tire defects. The product can be used directly by spraying. Short drying time and low consumption makes MN2400 very economical to use. The color of the sprayed layer is lighter after drying. lt does not affect the color codes on the tires and is easily identifiable.

|Use|

Aucde MN2400 is sprayed with air-atomizing guns onto the surface of the green tire. Slow stirring before use is advantageous. In the case of a long production pause or shift interval, the spray gun should be flushed after use to prevent the spray nozzle from clogging by the dry film of the paint.

Product containers or drums should be sealed immediately after use.

|Dosage|

The ideal amount depends on the different application operating equipment, tire size and production process of each factory.

|Packing|

50kg/plastic drum

|Storage stability|

Recommended storage temperature: 2 - 45 °C.

In original closed containers under cool and dry conditions 6 months from date of production. Avoid freezing.

|Safety and Transport|

Aucde MN2400 is not classified as dangerous for transport according to transport regulations. Proper use of this product will not cause any harm.

|Special declaration|

Our technical information is given in good faith but without warranty, and this also applies where proprietary rights of third parties are involved. It does not release you from the obligation to test the products supplied by us as to their suitability for the intended processes and uses.